n No virtual APs are defined on the AP.
n The AP has profile errors. For details, access the command-line interface and issue the command “show
profile errors”.
n The GRE tunnel between the AP and the switch was blocked by a firewall after the AP became active.
n The AP is temporarily down while it is upgrading its software. The AP will become active again after
upgrading.
Optional AP Configuration Settings
Once the AP has been installed and provisioned, you can use the WebUI or CLI to configure the optional AP
settings described in the following sections:
n Changing the AP Installation Mode on page 543
n Renaming an AP on page 544
n Enabling Flexible Radio on page 545
n Enabling Spanning Tree on page 545
n Enabling PortFast on page 545
n Enabling PortFast On Trunk on page 546
n QoS for AP Management Traffic on page 547
n Frame Drop Counter on page 548
n DSCP to 802.1p Priority Mapping on page 548
n AP Console Access Using a Backup ESSID on page 549
n Defining an RTLS Server on page 549
n AP Redundancy on page 550
n AP Maintenance Mode on page 551
n Energy Efficient Ethernet on page 552
n AP LEDs on page 553
n Suppressing Client Probe Requests on page 554
n BLE Operation Mode on page 555
Changing the AP Installation Mode
By default, all AP models initially ship with an indoor or outdoor installation mode. This means that APs with an
indoor installation mode are normally placed in enclosed, protected environments and those with an outdoor
installation mode are used in outdoor environments and exposed to harsh elements.
In most countries, there are different channels and power that are allowed for indoor and outdoor operation.
You may want to change an AP’s installation mode from indoor to outdoor or vice versa.
In the WebUI
To configure the installation mode for an AP, follow these steps:
1. Navigate to the Configuration > Wireless> AP Installation page. The list of discovered APs are displayed
on this page.
2. Select the AP you want to change.
3. Click Provision to reveal the Provisioning page.
Locate the AP Installation Mode section. By default, the Default mode is selected. This means that the
AP installation type is based on the AP model.
AOS-W 6.5.3.x | User Guide Access Points | 543
To Next Page
Loading...