Alcatel-Lucent AOS-W 6.5.3.x

To Next Page

To Previous Page

Parameter Description

Enable Anyspot Select this checkbox to enable the anyspot feature. Note that you must associate the any-

spot profile with a virtual AP profile for the settings to take effect.

Exclude ESSID(s)

(exact match)

An anyspot-enabled radio will not respond to client probe requests using an ESSID in the

Exclude ESSID lists. To add an ESSID to the list, enter the full name of the ESSID, then

click Add. To remove an ESSID from the list, select it and click Delete. ESSIDs from neigh-

boring APs will automatically appear in this list as long as the anyspot-enabled AP can

detect that ESSID.

Exclude ESSID(s) (con-

taining string(s)

An anyspot-enabled radio will not respond to client probe requests using an ESSID in the

Exclude ESSID list. To exclude ESSIDs that partially match a text string, enter that string

then click Add. To remove a matching string from the list, select it and click Delete.

Preset ESSID(s) The anyspot-enabled AP will not send an ESSID in beacons, but if a client sends a probe

requests without ESSIDs (that is, the probe request is not looking for a specific network)

then the anyspot-enabled AP will respond to the probe request with an ESSID from this list.

Table 126: Anyspot Client Probe Suppression Configuration Parameters

In the CLI

Use the following commands to configure the anyspot profile, and associate an anyspot profile with a virtual

AP.

wlan anyspot-profile <anyspot-profile>

wlan virtual-ap <virtual-ap-profile>

anyspot-profile <anyspot-profile>

BLE Operation Mode

Starting from AOS-W 6.4.3.3, the BLE Operation Mode setting is introduced. This setting determines how the

built-in Bluetooth Low Energy (BLE) chip in the AP functions. You can configure this setting using the switch

WebUI or CLI.

In the WebUI

1. Navigate to the Configuration >WIRELESS >AP Configuration page.

2. In the AP Group tab, click the desired profile.

3. In the Profiles list, navigate to the AP >AP system profile menu.

4. In the Advanced tab of the Profile Details section, configure the BLE Operation Mode setting described

in Table 127.

AOS-W 6.5.3.x | User Guide Access Points | 555

Alcatel-Lucent AOS-W 6.5.3.x - Page 555