Alcatel-Lucent AOS-W 6.5.3.x - Configuring H2 QP OSU Provider List Profiles

915| 802.11u Hotspots AOS-W 6.5.3.x| User Guide
Parameter Description
WAN Metrics uplink
load
This parameter defines the percentage of the WAN uplink that is currently utilized. If
no value is set, this parameter will show a default value of 0 to indicate that the down-
link speed is unknown or unspecified.
Range: 0-100; Default: 0
WAN Metrics downlink
load
This parameter defines the percentage of the WAN downlink that is currently in use. If
no value is set, this parameter will show a default value of 0 to indicate that the
downlink speed is unknown or unspecified.
Range: 0-100; Default: 0
WAN Metrics load meas-
urement duration
Duration over which the downlink load is measured, in tenths of a second.
Range: 0-65535; Default: 0
In the CLI
To configure a H2QP WAN metrics profile from the switch CLI, access the CLI in config mode and issue the
following commands:
wlan hotspot h2qp-wan-metrics-profile <profile-name>
at-capacity
clone <profile-name>
downlink-load
downlink-speed
load-dur
no ...
symm-link
uplink-load
uplink-speed
wan-metrics-link-status link_down|link_test|link_up|reserved
Configuring H2QP OSU Provider List Profiles
This profile defines a list of Online Sign Up (OSU) service providers available from the hotspot. When you
configure an OSUprovider list, if a customer device cannot find a service from a known operator, the device
receives a notification from the hotspot that additional OSU services are available. If the customer elects to
sign up, they are presented with a list of up to two Online Sign Up providers.
To send the values configured in this profile to clients, you must associate this profile with an advertisement
profile, then associate the advertisement profile with a hotspot 2.0 profile. For details, see Configuring Hotspot
Advertisement Profiles on page 899.
AOS-W supports up to two icon files per OSU provider. These files need to be uploaded to the switch as part of
the OSU provider configuration. When a Hotspot AP reboots, the AP downloads these icon files from the
switch.
In the WebUI
To configure an H2QP OSU Provider List profile from the switch WebUI:
1. Navigate to Configuration > Advanced Services > All Profiles.
2. In the Profiles list, expand the Wireless LAN section.
3. Select H2QP OSU Provider List Profiles