3. Insert your USB drive into the switch’s USB slot. Wait for 30 seconds for the switch to mount the USB.
4. Navigate to Upload Config in the LCD’s Maintenance menu. Confirm the upload (Y/N) and then wait for
the upload to complete.
5. Execute a system reboot either from the LCD menu or from the command line to reload from the uploaded
configuration.
For detailed upgrade and instruction, see the Upgrade chapter in the Release Notes.
Disabling LCD Menu Functions
For security purposes, you can disable all LCD menu functions by disabling the entire menu functionality using
the following commands:
(host) (config) #lcd-menu
(host) (lcd-menu) #disable menu
To prevent inadvertent menu changes, you can disable individual LCD menu functions using the following
commands:
(host) (lcd-menu) #disable menu maintenance ?
factory-default Disable factory default menu
media-eject Disable media eject menu on LCD
system-halt Disable system halt menu on LCD
system-reboot Disable system reboot menu on LCD
upgrade-image Disable image upgrade menu on LCD
upload-config Disable config upload menu on LCD
To display the current LCD functionality from the command line, use the following command:
(host) (config) #show lcd-menu
Configuring a VLAN to Connect to the Network
You must follow the instructions in this section only if you need to configure a trunk port between the switch
and another layer-2 switch (shown in Deployment Scenario #3: APs on Multiple Different Subnets from
Switches on page 37).
This section shows how to use both the WebUI and CLI for the following configurations (subsequent steps
show how to use the WebUI only):
n Create a VLAN on the switch and assign it an IP address.
n Optionally, create a VLAN pool. A VLAN pool consists of two more VLAN IDs which are grouped together to
efficiently manage multi-switch networks from a single location. For example, policies and virtual application
configurations map users to different VLANs which may exist at different switches. This creates redundancy
where one switch has to back up many other switches. With the VLAN pool feature you can control your
configuration globally.
VLAN pooling should not be used with static IP addresses.
n Assign to the VLAN the ports that you will use to connect the switch to the network. (For example, the
uplink ports connected to a router are usually Gigabit ports.) In the example configurations shown in this
section, a switch is connected to the network through its Gigabit Ethernet port 1/25.
n Configure the port as a trunk port.
n Configure a default gateway for the switch.
AOS-W 6.5.3.x | User Guide The Basic User-Centric Networks | 45
To Next Page
Loading...