44| The Basic User-Centric Networks AOS-W 6.5.3.x| User Guide
Table 16: LCD Panel Mode: Maintenance
Function/Menu Options Display Output
Upgrade Image Upgrade the software image on the selected partition from a predefined loc-
ation on the attached USB flash device.
Partition [0 | 1] Upgrade Image [no | yes]
Upload Config Uploads the switch’s current configuration to a predefined location on the
attached USB flash device.
Upload Config [no | yes]
Factory Default Allows you to return the switch to the factory default settings.
Factory Default [no | yes]
Media Eject Completes the reading or writing of the attached USB device.
Media Eject [no | yes]
System Reboot Allows you to reboot the switch.
Reboot [no | yes]
System Halt Allows you to halt the switch.
Halt [no | yes]
Exit Maintenance Menu EXIT MAINTENANCE
Using the LCD and USB Drive
You can upgrade your image or upload a saved configuration by using your USB drive and your LCD
commands.
For more information on copying and transferring AOS-W image and configuration files, see Managing Files on the
Switch on page 882
Upgrading an Image
1. Copy a new switch image onto your USB drive into a directory named /Alcatel-Lucentimage.
2. Insert your USB drive into the switch’s USB slot. Wait for 30 seconds for the switch to mount the USB.
3. Navigate to Upgrade Image in the LCD’s Maintenance menu. Select a partition and confirm the upgrade
(Y/N) and then wait for switch to copy the image from the USB drive to the system partition.
4. Execute a system reboot either from the LCD menu or from the command line to complete the upgrade.
Uploading a Saved Configuration
1. Make a copy of a switchconfiguration (with the .cfg file extension), and save the copied file with the name
Alcatel-Lucent_usb.cfg.
2. Move the saved configuration file onto your USB drive into a directory named /Alcatel-Lucentimage.
To Next Page
Loading...