Alcatel-Lucent AOS-W 6.5.3.x - Configuring PAN Firewall Integration

To Next Page

To Previous Page

692| Palo Alto Networks Firewall Integration AOS-W 6.5.3.x| User Guide

Client Version IsValue

Windows

Windows Mobile

Windows Phone 7

Configuring PAN Firewall Integration

A PAN profile must be created on the switch. Multiple PAN profiles can be configured and saved on the switch,

but only one profile can be active at a time. These profiles can be configured and applied using the AOS-W

WebUI or CLI.

The procedures in this chapter describe the steps to integrate a Palo Alto Networks firewall with a master or local

switch. For details on configuring PAN firewall integration with a branch office switch, see Branch

Integration with a Palo Alto Networks (PAN) Portal on page 226

Creating PAN Profiles

The first step in configuring PANfirewall integration is to create PAN Profiles. This profile provides the switch

with the information required for connecting to and interacting with the specified PAN firewall. The PAN profile

can be created using the WebUI or CLI.

This configuration is done and available on the master switch only. The configuration will be pushed to all connected

local switches.

Using the WebUI

To configure a new PAN profile, complete the following steps:

1. Navigate to Configuration > Advanced Services > All Profiles > Other Profiles > Palo Alto

Networks Servers.

2. Type the name of the PAN profile and click Add.

3. Click on the name of the name PAN profile to open the Profile Details window.

4. Enter the Host (IP address or hostname) of the PAN firewall

5. Enter the Port (1 – 65535) of the PAN Firewall.

6. Enter the Username of the PAN firewall. The user name is between 1 and 255 bytes in length. The

username must match the Admin account previously created on the PAN firewall.

7. Enter the Password of the username in PAN Firewall. The password is between 6 and 100 bytes in length.

The password must match the Admin account previously created on the PAN firewall.

8. Re-enter the Password entered in the previous step.

9. Click Add.

10.Click Apply.

Up to twenty (20) PAN firewalls are supported.