Alcatel-Lucent AOS-W 6.5.3.x - Whitelist Synchronization

888| Management Access AOS-W 6.5.3.x| User Guide
Parameter Description
CPPM IF-Map Interface Enables the feature
Host IP address IP address or hostname of the CPPM IF-MAP server
Username Username for the user who performs actions on the CPPM IF-MAP
server. Range must be between 1-255 bytes in length.
Password Password of the user who performs actions on the CPPM IF-MAP
server. Range between 6-100 bytes in length.
Table 205: CPPM IF-Map Configuration Parameters
In the CLI
To configure this feature using the CLI:
(host) (config) #ifmap
(host) (config) #ifmap cppm
(host) (CPPM IF-MAP Profile) #server host <host>
(host) (CPPM IF-MAP Profile) #port <port>
(host) (CPPM IF-MAP Profile) #passwd <psswd>
(host) (CPPM IF-MAP Profile) #enable
This show ifmap cppm command shows if the CCPM interface is enable and the CPPM server IP address,
username and password.
(host) (CPPM IF-MAP Profile) #show ifmap cppm
CPPM IF-MAP Profile
-------------------
Parameter Value
--------- -----
CPPM IF-MAP Interface Enabled
CPPM IF-MAP Server 10.4.191.32:443 admin/********
This show command shows if state of all enabled CPPM servers.
(host) (CPPM IF-MAP Profile) #show ifmap state cppm
CPPM IF-MAP Connection State [Interface: Enabled]
-------------------------------------------------
Server State
------ -----
10.4.191.32:443 UP
Whitelist Synchronization
AOS-W allows switches to synchronize their remote AP whitelists with the Alcatel-Lucent Activate cloud-based
services. When you configure Activate whitelist synchronization, the switch will securely contact the Activate
server and download the contents of the whitelist on the Activate server to the whitelist on the switch. The
switch and the Activate server must have layer-3 connectivity to communicate.
By default, this feature will both add new remote AP entries to the switch whitelist and delete any obsolete
entries on the switch whitelist that were not on the Activate server whitelist. Select the add-only option to allow
this feature to add or modify entries, but not delete any existing entries.
In the WebUI
To enable this feature using the WebUI,
1. Navigate to Configuration > Network > Controller > Sync Whitelist Service.