Alcatel-Lucent AOS-W 6.5.3.x - Configuring H2 QP Operating Class Indication Profiles

913| 802.11u Hotspots AOS-W 6.5.3.x| User Guide
Parameter Description
Operator Friendly Name Lan-
guage Code
An ISO 639 language code that identifies the language used in the Oper-
ator Friendly Name field
Operator Friendly Name
An operator-friendly name sent by devices using this profile. The name
can be up to 64 alphanumeric characters, and can include special
characters and spaces. If the name includes quotation marks (“), include
a backslash character (\) before each quotation mark. (e.g. \"example\")
Table 217: H2QP Operator Friendly Name Profile Parameters
In the CLI
To configure a H2QP operator friendly name profile from the switch CLI, access the CLI in config mode and
issue the following commands:
wlan hotspot h2qp-operator-friendly-name-profile <profile>
clone <profile-name>
no ...
op-fr-name <op-fr-name>
op-lang-code <op-lang-code>
Configuring H2QP Operating Class Indication Profiles
The values configured in this H2QP Operating Class Indication profile list the channels on which the hotspot is
capable of operating. It may be useful where, for instance, a mobile device discovers a hotspot in the 2.4 GHz
band but finds it is dual-band and prefers the 5 GHz band.
To send the values configured in this profile to clients, you must associate this profile with an advertisement
profile, then associate the advertisement profile with a hotspot 2.0 profile. For details, see Configuring Hotspot
Advertisement Profiles on page 899.
In the WebUI
To configure a H2QP operating class indication profile from the switch WebUI:
1. Navigate to Configuration>Advanced Services>All Profiles.
2. In the profiles list, expand the Wireless LAN section.
3. Select H2QP Operating Class Indication.
4. Select an existing profile from the list of profiles on the profile details pane or create a new profile by
entering a profile name into the entry blank, then clicking Add.
5. In the H2QP Operating Class field, enter a valid operating class value. (For a definition of these global
operating classes refer to Table E-4 of IEEE Std 802.11-2012, Annex E.)
6. Click Apply.
In the CLI
To configure a H2QP operating class profile from the switch CLI, access the CLI in config mode and issue the
following commands:
wlan hotspot h2qp-op-cl-profile <profile>
clone <profile-name>
op-cl <1-255>