179| Authentication Servers AOS-W 6.5.3.x| User Guide
Figure 37 represents a server group named “Radii” that consists of two RADIUS servers, Radius-1 and Radius-2.
The server group is assigned to the server group for 802.1X authentication.
Figure 37 Server Group
Server names are unique. You can configure the same server in multiple server groups. You must configure the
server before you can add it to a server group.
If you use the switch’s internal database for user authentication, use the predefined “Internal” server group.
You can also include conditions for server-derived user roles or VLANs in the server group configuration. The
server derivation rules apply to all servers in the group.
Configuring Authentication Servers
This section describes how to configure RADIUS, LDAP, TACACS+ and Windows external authentication servers
and the internal database on the switch.
This section includes the following information:
n Configuring a RADIUS Server on page 179
n RADIUS Service-Type Attribute on page 181
n Enabling Radsecon RADIUS Servers on page 182
n Configuring Username and Password for CPPM Authentication on page 192
n on page 192
n Configuring an LDAP Server on page 192
n Configuring a TACACS+ Server on page 193
n Configuring a Windows Server on page 196
Configuring a RADIUS Server
Follow the procedures below to configure a RADIUS server using the WebUIor CLI.
Using the WebUI
1. Navigate to the Configuration > Security > Authentication > Servers page.
2. Select Radius Server to display the Radius Server List.
3. To configure a RADIUS server, enter the name for the server and click Add.
To Next Page
Loading...