Alcatel-Lucent AOS-W 6.5.3.x - Page 181

181| Authentication Servers AOS-W 6.5.3.x| User Guide
Parameter Description
Source Interface Enter a VLAN number ID.
Allows you to use source IP addresses to differentiate RADIUS requests.
Associates a VLAN interface with the RADIUS server to allow the server-
specific source interface to override the global configuration.
n If you associate a Source Interface (by entering a VLAN number) with a
configured server, then the source IP address of the packet is that
interface’s IP address.
n If you do not associate the Source Interface with a configured server (leave
the field blank), the IP address of the global Source Interface is used.
Use MD5 Use MD5 hash of cleartext password.
Default: Disabled
Mode Enables or disables the server.
Default: Enabled
Lowercase MAC
addresses
Send MAC address with lowercase in the authentication and accounting
requests to this server.
Default: Disabled
MAC address delimiter Send MAC address with the following delimiters in the authentication and
accounting requests of this server:
n colon: Send MAC address as XX:XX:XX:XX:XX:XX
n dash: Send MAC address as XX-XX-XX-XX-XX-XX
n none: Send MAC address as XXXXXXXXXXXX
n oui-nic: Send MAC address as XXXXXX-XXXXXX
Default: none
Service-type of FRAMED-
USER
Send the service-type as FRAMED-USER instead of LOGIN-USER. For more
information, see RADIUS Service-Type Attribute on page 181.
Default: Disabled
Radsec Enable or disable RADIUS over TLS for this server.
Default: Disabled
Radsec Trusted CA Name Enter the trusted CA name to be used to verify this server.
Radsec Server Cert Name Enter the name of the trusted Radsec server certificate.
Radsec Client Cert Enter the name of the Radsec client certificate that the switch should use for
Radsec requests.
called-station-id Allows user to send different values for Called Station ID. Configure the
following parameters for Called Station ID:
n csid_type: Called station ID type.
Default: macaddr
n include_ssid: Enabling this option includes SSID in the Called Station ID
along with csid_type.
Default: disabled
n csid_delimiter: Enabling this option allows to send this delimiter to
separate csid_type and ssid in the Called Station ID.
Default: colon
(example: 00-1a-1e-00-1a-b8:dotx-ssid)
Table 41: RADIUS Server Configuration Parameters
RADIUS Service-Type Attribute
The switch sends the following Service-Type attribute values for RADIUS authentication requests.