Creating and Installing an Internal Captive Portal
If you do not wish to customize the default captive portal page, you can use the following procedures to create
and install a new internal captive portal page. This section describes the following topics:
n Creating a New Internal Web Page on page 330
n Installing a New Captive Portal Page on page 332
n Displaying Authentication Error Messages on page 332
n Reverting to the Default Captive Portal on page 333
n Configuring Localization on page 333
n Customizing the Welcome Page on page 336
n Customizing the Pop-Up box on page 338
n Customizing the Logged Out Box on page 339
Creating a New Internal Web Page
In addition to customizing the default captive portal page, you can also create your own internal web page. A
custom web page must include an authentication form to authenticate a user. The authentication form can
include any of the following variables listed in Table 79:
AOS-W 6.5.3.x | User Guide Captive Portal Authentication | 330
To Next Page
Loading...