Alcatel-Lucent AOS-W 6.5.3.x - TACACS over Ipv6

145| IPv6 Support AOS-W 6.5.3.x| User Guide
In the WebUI
To configure an IPv6 host for a RADIUS server:
1. Navigate to the Configuration > Security > Authentication > Servers page.
2. Select RADIUS Server to display the RADIUS server List.
3. Select the required RADIUS server from the list to go to the Radius server page.
4. To enable the RADIUS server in IPv6 mode select the Enable IPv6 check box.
5. To configure an IPv6 host for the selected RADIUS server specify an IPv6 address or an FQDN in the Host
field.
6. Click Apply.
To configure an IPv6 address for the NAS-IP:
1. Select the Advanced tab.
2. Specify an IPv6 address in the NAS IPv6 field.
3. Click Apply.
To configure an IPv6 global source-interface:
1. Select the Advanced tab.
2. To configure the IPv6 loopback interface as the source interface, select loopback from the Source
Interface v6 drop-down list.
3. To configure a VLAN interface as the source interface, specify the VLAN interface and the IPv6 address in
the Source Interface v6 field.
4. Click Apply.
Radius Accounting for IPv6 Clients
Starting from AOS-W 6.5, customers can monitor bandwidth usage by clients/hosts with IPv6 addresses over
Radius Accounting for IPv6 Clients (RADIUS) protocol. The Framed-IPv6-Address attribute is used in
accounting start, stop, and interim packets. A host can have multiple IPv6 addresses and all of them are
tracked to check the usage for billing purpose.
TACACS Over IPv6
AOS-W provides support for TACACS authentication server over IPv6. You can configure the global IPv6
address as the host for TACACS authentication using CLI or WebUI.
In the CLI
(host)(config) #aaa authentication-server tacacs IPv6
(host)(TACACS Server "IPv6") #host <ipv6-address>
In the WebUI
1. Navigate to the Configuration > Security > Authentication > Servers page.
2. SelectTACACS Server to display the Server List.
3. Select the required server from the list to go to the TACACS server page.
4. To configure an IPv6 host for the selected server, specify an IPv6 address in the Host field.
5. Click Apply.