Alcatel-Lucent AOS-W 6.5.3.x - Page 547

Figure 71 Enabling PortFast On Trunk
Ensure the Switchport mode is trunk by changing the value in the Basic tab of the AP.
Figure 72 Apply Switchport Mode-Trunk
5. Click Apply.
In the CLI
Execute the following commands in config mode to enable PortFast.
Before enabling PortFast ensure that the switchport mode is set to access using the ap wired-ap-profile
command.
(host)(config) #ap wired-port-profile "default"
(host) (AP wired port profile "default") #portfast
To disable PortFast execute the no portfast command in the config mode.
(host) (AP wired port profile "default") #no portfast
The following example displays the spanning tree information of an AP, using the CLI command:
(host) (config) #show ap wired-port-profile <ap-name>
Execute the following commands in config mode to enable PortFast on trunk.
Before enabling PortFast ensure that the switchport mode is set to access using the ap wired-ap-profile
command.
(host)(config) #ap wired-port-profile "default"
(host) (AP wired port profile "default") #portfast on trunk
To disable PortFast on trunk execute the no portfast on trunk command in the config mode.
(host) (AP wired port profile "default") #no portfast
Before enabling PortFast on trunk ensure that the switchport mode is set to trunk using the ap wired-ap-
profile command.
QoS for AP Management Traffic
Management traffic on the AP can be marked with Differentiated Service Code Point (DSCP)values to apply a
priority level to that traffic.
AOS-W 6.5.3.x | User Guide Access Points | 547