Alcatel-Lucent AOS-W 6.5.3.x - Page 546

546| Access Points AOS-W 6.5.3.x| User Guide
n Spanning Tree should be enabled on the access point before enabling PortFast.
n If PortFast is configured, it is enabled only on access mode ports and if PortFast-Trunk is configured, it is
enabled on trunk-mode ports only. Only one of them can be set based on the port’s switchport mode.
Follow the steps below to enable PortFast/PortFast Trunk through the WebUI and command line.
In the WebUI
1. Navigate to Configuration > Advanced Services > All Profiles.
2. Click profile AP > AP wired port.
3. Select the AP profile to enable PortFast.
4. Select the Portfast checkbox.
Figure 69 Enabling PortFast
Ensure the Switchport mode is access by changing the value in the Basic tab of the AP.
Figure 70 Apply Switchport Mode-Access
5. Click Apply.
Enabling PortFast On Trunk
In the WebUI
1. Navigate to Configuration > Advanced Services > All Profiles.
2. Click profile AP > AP wired port.
3. Select the AP profile to enable PortFast on trunk.
4. Select the Portfast on trunk checkbox.