704| Remote Access Points AOS-W 6.5.3.x| User Guide
Figure 100 Remote AP with Single Switch
Branch office users want continued operation of the branch office WLAN, even if the link to the corporate
network goes down. The branch office AP solves these requirements by providing the following capabilities on
the branch office WLAN:
n Local termination of 802.11 management frames which provides survivability of the branch office WLAN.
n All 802.1X authenticator functionality is implemented in the AP. The switch is used as a RADIUS pass-
through when the authenticator has to communicate with a RADIUS server (which also supports
survivability).
n 802.11 encryption/decryption is in the AP to provide access to local resources.
n Local bridging of client traffic connected to the WLAN or to an AP 70 enet1 port to provide access to local
resources.
Provisioning the Branch AP
You can provision the remote AP either using the switch or using the Zero Touch Provisioning method. For
more information on switch provisioning, see Configuring Installed APs on page 538. For more information on
Zero Touch Provisioning, see Provisioning 4G USB Modems on Remote Access Points on page 735.
Configuring the Branch AP
n Specify forward mode for the Extended Service Set Identifier (ESSID) in the virtual AP profile
n Specify remote AP operation in the virtual AP profile (The remote AP operates in standard mode by default.)
n Set how long the AP stays up after connectivity to switch has gone down in the SSID profile
n Set the VLAN ID in the virtual AP profile
n Set the native VLAN ID in the AP system profile
n Set forward mode for enet1 port
Remote APs support 802.1q VLAN tagging. Data from the remote AP will be tagged on the wired side.
Troubleshooting Remote AP
The following WebUI options are available to troubleshoot issues with remote AP:
n Using local debugging feature
n Viewing the remote AP summary report
n Viewing remote AP connectivity report
To Next Page
Loading...