In the WebUI
1. Navigate to the Configuration > Advanced Services > AirGroup page.
2. Select the AirGroup Settings tab.
3. Under Global Setting > AirGroup CPPM query interval, enter a value in the range of 1 to 24 hours.
4. Click Apply.
In the CLI
[no] airgroup cppm-server query-interval <1..24>
Sample Configuration
(host) (config) #airgroup cppm-server query-interval 9
Viewing the CPPM Query Interval
The following procedure displays the configured CPPM query interval value.
In the WebUI
1. Navigate to the Configuration > Advanced Services > AirGroup page.
2. Select the AirGroup Settings tab. The AirGroup CPPM query interval displays the value in hours under
the Global Setting section.
In the CLI
show airgroup cppm-server query-interval
Sample Configuration
(host) #show airgroup cppm-server query-interval
CPPM Server Query Interval
--------------------------
Timer Value Unit
----------- ----
9 hours
The output of this command includes the following information:
Column Description
Timer Value
Displays the number of hours.
Unit
Displays the unit in hours.
Table 252: show airgroup cppm-server query-interval
Defining a CPPM and RFC3576 Server
You must define one or more CPPM servers to be used by the AirGroup RADIUS client, and an RFC 3576
(dynamic authorization) server. If multiple CPPM servers are defined, the servers are listed in a sequential
order. The AirGroup RADIUS client will use the first available server on this list.
Table 253 describes the configuration parameters for a CPPM server.
AOS-W 6.5.3.x | User Guide AirGroup | 1022
To Next Page
Loading...