Alcatel-Lucent AOS-W 6.5.3.x - Page 1032

3. If AP uplink is a trunk port with native VLAN as x, allowed VLANs as x, y, and z, and if the uplink-VLAN is
configured as VLANy for AP, the APperforms mDNSaggregation for VLAN y. Perform following
configuration:
l Configure uplink-VLANas VLAN y in the provisioning parameters of the APand reboot the AP.
l Create VLAN on switch using command vlan y.
l Configure native VLAN in system profile as VLAN x.
l Enable parameter APMulticast Aggregation in ap-system profile.
In the CLI
1. Create VLANfor APon the switch by using the following command:
(host) (config) #vlan <vlan id>
If an AP is connected on the trunk port, then configure the native VLAN of the trunk port using this command. If
uplink-VLAN is configured for the AP, then use this VLAN.
2. Configure the native VLANID for AP by using the following command:
(host) (config) #ap system-profile <profile-name>
(host) (ap system-profile "<profile-name>") #native-vlan-id <vlan-id>
If an AP is connected on the trunk port, then configure the native VLAN of the trunk port using this command.
3. Enable mDNS aggregation feature.
(host) (config) #ap system-profile <profile-name>
(host) (ap system-profile "<profile-name>") #mcast-aggr
4. Map the APsystem-profile to APname.
(host) (config) #ap-name <ap-name>
(host) (ap-name "<ap-name>") #ap-system-profile <profile-name>
In the WebUI
To enable AirGroup using the switch WebUI:
1. Navigate to Configuration > Advanced Services > AirGroup.
2. Select Settings tab.
3. Under Global Setting > AirGroup Status, select Enabled from the drop-down list.
4. Click Apply.
To enable mDNS APVLANaggregation using the switch WebUI:
1. Navigate to Configuration > Advanced Services > All Profiles.
2. Under Profiles, select AP > APSystem > <Profile-Name>.
3. Under Basic > General, select the checkbox next to APmulticast aggregation.
4. Click Apply.
In the CLI
To enable AirGroup using the switch CLI:
(host) (config) #airgroup enable
To enable mDNS APVLANaggregation using the switch CLI:
(host) (config) #ap system-profile <profile-name> mcast-aggr
AOS-W 6.5.3.x | User Guide AirGroup | 1032