1045| Instant AP VPN Support AOS-W 6.5.3.x| User Guide
b3c65c...
b3c65c... 2(10.15.205.0-10.15.205.250,5),1(10.15.206.1-10.15.206.252,5)
a2a65c... 0
b3c65c... 7(10.15.205.0-10.15.205.250,5),8(10.15.206.1-10.15.206.252,5)
b3c65c...
b3c65c... 1(10.15.205.0-10.15.205.250,5),2(10.15.206.1-10.15.206.252,5)
b3c65c... 14(10.15.205.0-10.15.205.250,5),15(10.15.206.1-10.15.206.252,5)
The output of this command includes the following parameters:
Parameter Description
Name
Displays the name of the branch.
VC MAC Address
Displays the MAC address of the Virtual Switch of the branch.
Status
Displays the current status of the branch (UP/DOWN).
Inner IP
Displays the internal VPN IP of the branch.
Assigned Subnet
Displays the subnet mask assigned to the branch.
Assigned Vlan
Displays the VLAN ID assigned to the branch.
Key
Displays the key for the branch, which is unique to each branch.
Bid(Subnet Name)
Displays the Branch ID (BID) of the subnet.
n In the example above, the switch displays bid-per-subnet-per-branch i.e., for "LA"
branch, BID "2" for the ip-range "10.15.205.0-10.15.205.250" with client count per
branch "5"). If a branch has multiple subnets, it can have multiple BIDs.
n Branches that are in UP state and do not have a Bid(Subnet Name) means that
the IAP is connected to a switch which did not assign any bid for any subnet. In the
above example, "Paris-CB:D3:16" branch is UP and does not have a Bid(Subnet
Name) information. This means that either the IAP is connected to a backup
switch or connected to a primary switch without any distributed L2 or L3 subnets.
For more information on bid-per-subnet-per-branch and distributed L2 and L3
subnets, see the DHCP Configuration chapter of the Alcatel-Lucent Instant Access Point
6.2.1.0-3.3 User Guide.
Table 258: IAP Table Parameters
Executing the show iap table command does not display the Key and Bid(Subnet Name) parameters.
To Next Page
Loading...