Alcatel-Lucent AOS-W 6.5.3.x - Page 1098

Predefined Role Permissions
network-operations
(continued)
Monitoring > Network > All Access PointsMonitoring
> Network > All Wired Access Points
You can view the reports created by the following CLI commands:
n DB:opcode=monitor-summary
n DB:opcode=cr-load
n DB:opcode=wlm-search&class=probes&start
n DB:opcode=wlm-search&class=amii
n DB:opcode=monitor-get-all-gps&status=any
n show ap-group
n show vlan status
Monitoring > Switch > Switch Summary
You can view the reports created by the following CLI commands:
n show switches
n show switches summary
Monitoring > Switch > Air Monitors
You can view the reports created by the following CLI commands:
n show wlan-ap start
*
Monitoring > Switch > Clients
You can view the reports created by the following CLI commands:
n show ip mobile host
n show ip mobile trail {<ipaddr> | <macaddr>}
n <span class="CLI">show ap essid</span>
n show esi servers
n show esi ping
n show esi parser stats
n show private port status
*
n show vlan
n show port stats
n show spanning-tree interface fastethernet
<slot>/<module>/<port>
n show interface fastethernet <slot>/<module>/<port> counters
n clear counters fastethernet <slot>/<module>/<port>
n show snmp trap-queue <page>
Monitoring > Switch > Clients > Packet CaptureMonitoring
>Switch > Clients > LocateMonitoring
> Switch > Clients > Debug
You can view the reports created by the following CLI commands:
n aaa user debug mac
Monitoring > Switch> Clients > Disconnect
You can view the reports created by the following CLI commands:
n stm kick-off-sta <macaddr>
n aaa user logout <ipaddr>
AOS-W 6.5.3.x | User Guide Behavior and Defaults | 1098