When a port in a LAG is misconfigured (the partner device is different than the other ports), or the neighbor
timesout or can not exchange LACPDUs with the partner, the port status is displayed as “DOWN” (see the
following example):
(host)#show lacp 0 internal
Flags: S - Device is requesting Slow LACPDUs
F - Device is requesting fast LACPDUs
A - Device is in active mode P - Device is in passive mode
Port Flags Pri AdminKey OperKey State Num Status
---- ----- ---- -------- -------- ----- ---- -------
FE 1/1 SA 1 0x1 0x1 0x45 0x2 DOWN
FE 1/2 SA 1 0x1 0x1 0x45 0x3 UP
In the WebUI
Access LACP from the Configuration >Network >Port tabs. Use the drop-down list to enter the LACP values.
n LACP Group— the link aggregation group (LAG) number; the range is 0 to 7.
n Mode— active negotiation state or not in an active negotiation state indicated by the passive option.
n Priority—the port priority value; the range is 1-65535 and the default is 255.
n Timeout— time out value for the LACP session. The long default is 90 seconds; the short default is 3
seconds.
For information on configuring LACP on OAW-AP220 Series and OAW-AP270 Series access points, see Link
Aggregation Support on OAW-AP220 Series, OAW-AP270 Series, and OAW-AP320 Series on page 588
AOS-W 6.5.3.x | User Guide Link Aggregation Control Protocol | 159
To Next Page
Loading...