Alcatel-Lucent AOS-W 6.5.3.x - Page 186

VSA
Type Value
Description
Vendor
Name
Vendor
ID
Aruba-
WorkSpace-
App-Name
String 31
This VSA identifies an application supported by
Alcatel-Lucent WorkSpace.
Aruba 14823
Aruba-
Mdps-
Provisioning-
Settings
String 32
Used as part of the ClearPass Onboard technology,
this attribute allows the CPPM to signal back to the
onboard process the context of the device
provisioning settings that should be applied to the
device based on applied role mappings.
Aruba 14823
Aruba-
Mdps-
Device-
Profile
String 33 Used as part of the ClearPass Onboard technology,
this attribute allows CPPM to signal back to the
onboard process the device profile that should be
applied to the device based on applied role
mappings.
Aruba 14823
The following table describes the RTTSVSAs supported by AOS-W. You can view counters for the number of
times these attributes were sent and processed using the command show dot1x counters.
VSA
Type Value
Description
Vendor
Name
Vendor
ID
RTTS-Estim-
ated-Through-
put
integer 1
This Attribute can be used to transfer a UE through-
put estimation value from a RADIUS authenticator to
the cellular WLANswitch (via a RADIUS proxy).
Ericsson 10923
RTTS-Result integer 2
This Attribute can be used by the cellular WLANswitch
to transfer the result of a traffic steering decision to
the RADIUS authenticator.
Ericsson 10923
RTTS-Back-
off-Time
integer 3
This Attribute can be used by the cellular WLANswitch
in the Access-Accept packet to indicate to the WLAN
how long a rejected UE should be ignored before
being considered again for entry into the WLAN.
Ericsson 10923
RTTS-Rees-
timation-
Period
integer 4
This attribute is included by the cellular WLANswitch
in the Access-Accept packet when RTTS-Result is True
to indicate to the WLAN the required interval of time
between RTTS Throughput estimates to be sent to the
CWC for the UE.
Ericsson 10923
RTTS-Reest-
Below-
Throughput
integer 5
This Attribute is included by the cellular WLANswitch
in the Access-Accept packet when RTTS-Result is True
to indicate to the WLAN the level below which RTTS
Accounting-Request packets should be sent.
Ericsson 10923
RTTS-Reest-
Keepalive-
Num
integer 6
This attribute is included by the cellular WLANswitch
when RTTS-Result is True in order to ensure that not
too many reestimations are skipped by the WLAN due
to the UE Wi-Fi estimated throughput being constantly
higher than the RTTS-Reestimate-When-Below-Tput
threshold.
Ericsson 10923
Table 44: RTTS RADIUS VSAs
The following table describes the Hotspot 2.0 VSAs supported by AOS-W.
AOS-W 6.5.3.x | User Guide Authentication Servers | 186