4. For User Name and Password, enter the MAC address for the client. Use the format specified by the
Delimiter parameter in the MAC Authentication profile. For example, if the MAC Authentication profile
specifies the default delimiter (none), enter MAC addresses in the format xxxxxxxxxxxx.
5. Click Enabled to activate this entry on creation.
6. Click Apply.
The configuration does not take effect until you perform this step.
In the CLI
Enter the following command in enable mode:
(host)(config) #local-userdb add username <macaddr> password <macaddr>...
AOS-W 6.5.3.x | User Guide MAC-based Authentication | 214
To Next Page
Loading...