Alcatel-Lucent AOS-W 6.5.3.x

To Next Page

To Previous Page

Parameter Description

PacketBurst Per Probe

The Pocket Burst per Probe field specifies the number of probes to be sent

during the probe interval. To change the default value of 5 probes, enter a new

value into this field.

Probe Retries

The number of times the switch will attempt to resend a probe.

WAN Optimization

Compression The Compression/Decompression Engine feature is enabled by default. However,

the packets are compressed only if the IP Payload Compression Protocol (IPComp)

is successfully negotiated via the Internet Key Exchange (IKE) protocol.

BW Management

Uplink

Select an interface uplink to which you will apply the bandwidth contract.

Service Type

Select one of the available service types for this bandwidth contract:

n None: The contract applies to all upstream or downstream traffic on the

interface.

n Application: The contract applies to a specific application.

n Category: The contract applies to all applications within a category type.

n Exclude: If a bandwidth contract is applied to an entire interface or category of

applications, you can create a bandwidth contract that excludes a single

application or application category from that contract.

Bandwidth Contract

If you chose the None, Application or Category option in the Service Type field,

select the name of the bandwidth contract to be applied to the interface.

Application

If you chose the Application option in the Service Type field, select the applic-

ation to which the bandwidth policy will be applied.

Alcatel-Lucent AOS-W 6.5.3.x - Page 253