Alcatel-Lucent AOS-W 6.5.3.x - Page 258

258| BranchSwitch Config for Cloud Services Switches AOS-W 6.5.3.x| User Guide
The WAN Summary page contains the following tables:
n Status : This section of the WAN Dashboard includes tabs that displays information for the status of
monitored links, and for deployments using Layer-3 redundancy the status of the branch connectivity to
the primary and secondary master switches.
l Status: This section displays the link status and WAN status for VLANs monitored using the uplink
manager utility. For each VLAN, the green represents an up status and red represents a down status for
the link and WAN. The uplink health-check feature is enabled by default on branch switches. If it is
disabled, the WAN status link will appear orange, indicating that this feature is in an error state.
l Layer3 Redundancy: This section displays the status of the branch switch's connection to the primary
master and secondary master switches defined during the branch switch's provisioning process.
n Throughput : Displays the In and Out traffic for VLANs. The Throughput table has four tabs for different
uplinks. First tab shows throughput of VLANs having high priority followed by other VLAN data based on its
priority. Clicking on each tab loads In and Out traffic throughput data for that particular VLAN.
n Latency :Displays Latency data for available VLANs.Each line represents one VLAN.
n Alerts : Lists the last five alerts with time stamp and description.
n Usage : Displays traffic based on Application Category or Application.
n Compression : Displays compression that occurred on all VLANs together.