Alcatel-Lucent AOS-W 6.5.3.x - Page 323

323| Captive Portal Authentication AOS-W 6.5.3.x| User Guide
Parameter Description
Logon Page URL of the page that appears before logon. This can be set to any URL.
Default: /auth/index.html
Welcome Page URL of the page that appears after logon and before redirection to the web URL. This
can be set to any URL.
Default: /auth/welcome.html
Show Welcome
Page
Displays the configured welcome page before the user is redirected to their original
URL. If this option is disabled, users are redirected to the web URL immediately after
they log in.
Default: Enabled
Add switch IP
address in
redirection URL
Sends the switch’s IP address in the redirection URL when external captive portal
servers are used. An external captive portal server can determine the switch from
which a request originated by parsing the ‘switchip’ variable in the URL.
Default: Disabled
Add User VLAN in
the Redirection URL
Sends the user’s VLAN ID in the redirection URL when external captive portal servers
are used.
Add a switch inter-
face in the redir-
ection URL
Sends the switch’s interface IP address in the redirection URL when external captive
portal servers are used. An external captive portal server can determine the switch
from which a request originated by parsing the ‘switchip’ variable in the URL. This
parameter requires the Public Access license.
Allow only one
active user session
Allows only one active user session at a time.
Default: Disabled
White List To add a netdestination to the captive portal whitelist, enter the destination host or
subnet, then click Add. The netdestination will be added to the whitelist. To remove a
netdestination from the whitelist, select it in the whitelist field, then click Delete.
If you have not yet defined a netdestination, use the CLI command netdestination to
define a destination host or subnet before you add it to the whitelist.
This parameter requires the Public Access license.
Black List To add a netdestination to the captive portal blacklist, enter the destination host or
subnet, then click Add. The netdestination will be added to the blacklist. To remove a
netdestination from the blacklist, select it in the blacklist field, then click Delete.
If you have not yet defined a netdestination, use the CLI command netdestination to
define a destination host or subnet before you add it to the blacklist.
Show Acceptable
Use Policy Page
Show the acceptable use policy page before the logon page.
Default: Disabled