36| The Basic User-Centric Networks AOS-W 6.5.3.x| User Guide
n Set the default gateway to the IP address of the interface of the upstream router to which you will
connect the switch.
2. Connect the uplink port on the switch to the switch or router interface. By default, all ports on the switch
are access ports and will carry traffic for a single VLAN.
3. Deploy APs. The APs will use the Alcatel Discovery Protocol (ADP) to locate the switch.
4. Configure the SSID(s) with VLAN 1 as the assigned VLAN for all users.
Deployment Scenario #2: APs All on One Subnet Different from Switch Subnet
Figure 2 APs All on One Subnet Different from Switch Subnets
In this deployment scenario, the APs and the switch are on different subnetworks and the APs are on multiple
subnetworks. The switch acts as a router for the wireless subnetworks (the switch is the default gateway for
the wireless clients). The uplink port on the switch is connected to a layer-2 switch or router; this port is an
access port in VLAN 1.
For this scenario, you must perform the following tasks:
1. Run the initial setup wizard.
To Next Page
Loading...