Alcatel-Lucent AOS-W 6.5.3.x - Page 419

6. To associate a different profile with the Virtual APprofile, click the name of any currently associated profile
in the Profiles list.
7. Click the drop-down list at the top of the ProfileDetails pane and select a different profile to associate to
the Virtual AP.
8. Click Apply.
Configuring a Virtual AP in the CLI
The following example defines a virtual AP using the command-line interface. For additional information on the
suggested order of steps to configure a virtual AP using the command-line interface, see Virtual AP
Configuration Workflow on page 411.
(host)(config) #wlan virtual-ap "THR-VIRTUAL-AP-PROFILE-WPA2"
ssid-profile "THR-SSID-PROFILE-WPA2"
aaa-profile "THR-AAA-PROFILE-WPA2"
vlan 60
Associating a Virtual AP Profile to an AP or AP Group
Use the following procedures to associate a virtual APprofile to an AP or group of APs.
In the WebUI
1. Navigate to the Configuration > Wireless > AP Configuration page.
2. Do one of the following:
n To associate the Virtual APprofile to a single AP, click the AP specific tab, and select the AP.
n To associate the Virtual APprofile to an APgroup, click the AP Group tab, and select the AP Group.
3. In the Profiles list, expand the Wireless LAN menu.
4. Select Virtual AP. The Profile Details window displays the Virtual AP profiles currently associated to the AP
or AP group.
5. Click the Add a Profile drop-down list and select a new Virtual AP profile to associate to the AP. You can
associate multiple APprofiles to an AP, but each virtual AP profile must reference a SSID profile with a
different network name (SSID).
6. Click Apply
Although you can create mutliple Virtual AP profiles that reference a single SSID profile, only one of these profiles
can be applied to an AP or AP group.
In the CLI
(host) (config)#ap-group <ap-group> virtual-ap <vap-profile>
Excluding a Virtual AP Profile
You can exclude one or more virtual AP profiles from an individual AP. This prevents a virtual AP, defined at the
AP group level, from being applied to a specific AP. For example, you can apply the virtual AP profile that
corresponds to the “Corpnet” SSID to the “default” AP group. If you do not want the “Corpnet” SSID to be
advertised on the AP in the lobby, you can specify the virtual AP profile that contains the “Corpnet” SSID
configuration be excluded from that AP.
In the WebUI
1. Navigate to the Configuration > Wireless > AP Configuration > AP Specific page.
2. Do one of the following:
n If the AP you want to exclude is included in the list, click Edit for the AP.
AOS-W 6.5.3.x | User Guide Virtual APs | 419