Alcatel-Lucent AOS-W 6.5.3.x - Page 433

Parameter Description
xSec Encryption and tunneling of Layer-2 traffic between the switch and wired or
wireless clients, or between switches. To use xSec encryption, you must use a
RADIUS authentication server. For clients, you must install the Funk Odyssey
client software.
Requires installation of the xSec license. For xSec between switches, you must
install an xSec license in each switch.
opensystem No authentication and encryption.
static-wep WEP with static keys.
dynamic-wep WEP with dynamic keys.
wpa-tkip WPA with TKIP encryption and dynamic keys using 802.1X.
wpa-aes WPA with AES encryption and dynamic keys using 802.1X.
wpa-psk-tkip WPA with TKIP encryption using a preshared key.
wpa-psk-aes WPA with AES encryption using a preshared key.
wpa2-aes WPA2 with AES encryption and dynamic keys using 802.1X.
wpa2-psk-aes WPA2 with AES encryption using a preshared key.
wpa2-psk-tkip WPA2 with TKIP encryption using a preshared key.
wpa2-tkip WPA2 with TKIP encryption and dynamic keys using 802.1X.
wpa2-aes-gcm-128 WPA2 with AES GCM-128 (Suite-b) encryption and dynamic keys using 802.1X.
NOTE: This parameter requires the ACR license. For further information on
Suite-B encryption, see Suite-B Cryptography on page 430.
wpa2-aes-gcm-256 WPA2 with AES GCM-256 (Suite-b) encryption and dynamic keys
using 802.1X.
NOTE: This parameter requires the ACR license. For further information on
Suite-B encryption, see Suite-B Cryptography on page 430.
Enable Management
Frame Protection
When selected, the SSID supports MFP-capable and traditional clients.
NOTE: MFP can only be enabled on SSIDs that support WPA2.
Require Management
Frame Protection
When selected, the SSIDsupports MFP-capable clients only.
NOTE: MFP can only be enabled on SSIDs that support WPA2.
DTIM Interval Specifies the interval, in milliseconds, between the sending of Delivery Traffic
Indication Messages (DTIMs) in the beacon. This is the maximum number of
beacon cycles before unacknowledged network broadcasts are flushed. When
using wireless clients that employ power management features to sleep, the
client must revive at least once during the DTIM period to receive broadcasts
Table 103: SSID Profile Parameters
AOS-W 6.5.3.x | User Guide Virtual APs | 433