Alcatel-Lucent AOS-W 6.5.3.x - Page 460

Setting Description Defaults
Max Tx EIRP Maximum effective isotropic radiated power (EIRP)
from 3 to 33 dBm in 3 dBm increments. You may
also specify a special value of 127 dBm for
regulatory maximum. Higher power level settings
may be constrained by local regulatory
requirements and AP capabilities. In the event that
an AP is configured for a Max Tx EIRP setting it
cannot support, this value will be reduced to the
highest supported power setting.
NOTE: Power settings will not change if the
Assignment option is set to disabled or maintain.
In 6.4.4.0 and later
releases:
n default-a: 18 dBm
n default-g: 9 dBm
In earlier 6.4.x
releases:
n default: 127dBm
Min Tx EIRP Minimum effective isotropic radiated power (EIRP)
from 3 to 33 dBm in 3 dBm increments. You may
also specify a special value of 127 dBm for
regulatory maximum to disable power adjustments
for environments such as outdoor mesh links. Note
that power settings will not change if the
Assignment option is set to disabled or maintain.
Higher power level settings may be constrained by
local regulatory requirements and AP capabilities. In
the event that an AP is configured for a Min Tx EIRP
setting it cannot support, this value will be reduced
to the highest supported power setting.
Default: 9 dBm
NOTE: Consider configuring a Min Tx Power setting
higher than the default value if most of your APs are
on the ceiling. APs on a ceiling often have good line
of sight between them, which will cause ARM to
decrease their power to prevent interference.
However, if the wireless clients down on the floor do
not have such a clear line back to the AP, you could
end up with coverage gaps.
In 6.4.4.0 and later
releases:
n default-a: 12 dBm
n default-g: 6 dBm
In earlier 6.4.x
releases:
n default: 9dBm
Rogue AP Aware If you have enabled both the Scanning and Rogue
AP options, Alcatel-Lucent APs may change
channels to contain off-channel rogue APs with
active clients. This security features allows APs to
change channels even if the Client Aware setting is
disabled.
This setting is disabled by default, and should only be
enabled in high-security environments where
security requirements are allowed to consume
higher levels of network resources. You may prefer
to receive Rogue AP alerts via SNMP traps or syslog
events.
Disabled
Table 107: ARM Profile Configuration Parameters
AOS-W 6.5.3.x | User Guide Adaptive Radio Management | 460