Alcatel-Lucent AOS-W 6.5.3.x - Page 500

Parameter Description
Unclassified APUpdate Enables or disables classification updates for monitored APs. If
this option is enabled, it helps decrease the delay in the speed at
which the devices are classified.
Default: Disabled
Unclassified Device Update Interval The time interval for the AP to send the WMS a list of unclassified
APs and clients. The minimum interval is 30 seconds.
Default: 60 seconds
Unclassified STAUpdate Enables or disables classification updates for monitored clients.
If this option is enabled, it helps decrease the delay in the speed
at which the devices are classified.
Default: Disabled
Table 116: IDSGeneral Profile Parameters
In the CLI
Use the following command to configure IDSGeneral Profile parameters using the CLI.
ids general-profile <profile-name>
unclass-ap-update
unclass-device-update-interval
unclass-sta-update
Managing List of Valid Exempt Clients
Starting with AOS-W 6.4.4, the administrator can configure clients to be exempted from valid station
protection and valid station misassociation detection by adding the mac-address of those devices to the valid-
exempt-list.
Once a client MAC address is added to the valid-exempt list:
n If the client exists in the WMS, the classification is set to valid.
n If the client does not exist in the WMS, a client entry is created and then the classification is set to valid.
n After the classification is done, APs that are seeing the client are notified that the client is added to the valid-
exempt list.
A maximum of 200 MAC addresses can be added to a valid-exempt list and this list is not retained after the switch
reboots or a process is restarted.
In the CLI
Use the following commands to add or remove MAC addresses from the valid-exempt list:
wms client <macaddr> valid-exempt insert
wms client <macaddr> valid-exempt remove
Use the following command to display a list of configured valid-exempt clients:
show wms client valid-exempt
Use the following command to display a list of clients that are viewed by the AP and marked as valid-exempt:
show ap monitor client-list ap-name <> valid-exempt
Use the following command to view the number of MAC addresses added to the valid-exempt client list:
show wms counters
Valid Exempt Station Macs
AOS-W 6.5.3.x | User Guide Wireless Intrusion Prevention | 500