Alcatel-Lucent AOS-W 6.5.3.x - Page 512

512| Access Points AOS-W 6.5.3.x| User Guide
ip-addr
ip6-addr
wired-mac
AP Deployment Policy
Starting with AOS-W 6.5.3.0, users can predefine the APmode using the APdeployment policy. The
APdeployment policy redirects all APs in the specified IP address ranges to the Instant discovery process,
ensuring that the APs run only in switch-less mode. This policy is enforced each time an AP in the specified IPv4
or IPv6 address range connects to a switch and upgrades to the AOS-W image. The switch automatically
identifies the targeted AP, rejects the APtermination, and redirects the APto upgrade to switch-less mode.
Users can define up to 128 IPv4 and IPv6 address ranges for the APdeployment policy.
In the CLI
To apply the APdeployment policy to the default APgroup, execute the following commands:
(host) (config) #ap deploy-profile
(host) (ap deploy-profile) #default-ap-group
To apply the APdeployment policy to an IPv4 address range, execute the following commands:
(host) (config) #ap deploy-profile
(host) (ap deploy-profile) #ip-range <start> <end>
To apply the APdeployment policy to an IPv6 address range, execute the following commands:
(host) (config) #ap deploy-profile
(host) (ap deploy-profile) #ipv6-range <start> <end>
To remove the IPaddress range or default APgroup from the profile, execute the following command:
(host) (config) #no ap deploy-profile
To view the complete list of IPaddress ranges to which the APdeployment policy is applied, execute the
following command:
(host) #show ap deploy-profile
Discovery Logic Workflow
The following steps describe the AP discovery logic: