Alcatel-Lucent AOS-W 6.5.3.x - Page 540

540| Access Points AOS-W 6.5.3.x| User Guide
Parameter Description
Initialization String The initialization string for the USB modem. This string configures the
Access Point Name (APN) setting of the USB modem. For the USB modem
to understand this string, the value entered should adhere to the following
formats:
n Prefix double-quotes with a backslash character. See example below:
"AT+CGDCONT=1,\"IP\",\"vendor\""
n Use single-quote instead of double-quotes. AP translates single-quote
into double-quotes. See example below:
"AT+CGDCONT=1,’IP’,’vendor’"
n Do not use double-quotes as a string begin-end pair. This is supported
by AP. See example below:
AT+CGDCONT=1,’IP’,’vendor’
This parameter only needs to be specified if the default string is incorrect.
Device Identifier The USB device identifier, if the device is not already supported.
Device Type Specify the USB driver type from the following list:
n acm: Use ACM driver
n airprime: Use Airprime driver
n beceem-wimax: Use Beceem driver for 4G-WiMAX
n ether: Use CDC Ether driver for direct IP4G device
n hso: Use HSO driver for newer Option
n none: Disable 3G or 2G network on USB
n option: Use Option driver
n pantech-3g: Same as "pantech-uml290" - to support upgrade
n pantech-uml290: Use Pantech USB driver for UML290 device
n ptumlusbnet: Use Pantech USB driver for 4G device
n rndis: Use a RNDIS driver for a 4G device
n sierra-evdo: Use EVDO Sierra Wireless driver
n sierra-gsm: Use GSMSierra Wireless driver
n sierrausbnet:Use SIERRA Direct IP driver for 4G device
n storage: Use USBflash as storage device for storing RAP certificates
Dial String The dial string for the USB modem. This parameter only needs to be
specified if the default string is incorrect.
PPP Username Enter the PPP username provided by the cellular service provider.
PPP Password Enter the optional PPP password provided by the cellular service provider.
Confirm PPP Password Re-enter the optional PPP password provided by the cellular service
provider.
Modeswitch USB cellular devices on remote APs typically register as modems, but may
occasionally register as a mass-storage device. If a remote AP cannot
recognize its USB cellular modem, use setting to specify the parameters
for the hardware model of the USB cellular data-card.
NOTE: You must enclose the entire modeswitch parameter string in
quotation marks. Example follows:
"-v <default_vendor> -p <default_product> -V <target_vendor> -P
<target_product> -M <message_content>"