Alcatel-Lucent AOS-W 6.5.3.x - Page 557

show ap system-profile
The following new parameter is introduced as part of the output of the show ap system-profile command:
Parameter Description
BLE Operation Mode
Displays the BLE operation mode of the AP.
Example
The following example displays the BLE operation mode.
(host) #show ap system-profile default
AP system profile "default"
---------------------------
Parameter Value
--------- -----
RF Band g
RF Band for AM mode scanning all
Native VLAN ID 1
Tunnel Heartbeat Interval 1
Session ACL ap-uplink-acl
...
...
...
BLE Endpoint URL N/A
BLE Auth Token N/A
BLE Operation Mode Disabled
AOS-W 6.5.3.x | User Guide Access Points | 557