Alcatel-Lucent AOS-W 6.5.3.x - Page 571

Parameter Description
Frame Error Rate Low
Watermark
After a frame error rate exceeded condition exists, the condition persists
until the frame error rate drops below this value. The recommended
value is 8%.
Frame Fragmentation Rate
High Watermark
If the frame fragmentation rate (as a percentage of total frames in an
AP) exceeds this value, a frame fragmentation rate exceeded condition
exists. The recommended value is 16%.
Frame Fragmentation Rate
Low Watermark
After a frame fragmentation rate exceeded condition exists, the
condition persists until the frame fragmentation rate drops below this
value. The recommended value is 8%
Frame Low Speed Rate High
Watermark
If the rate of low-speed frames (as a percentage of total frames in an AP)
exceeds this value, a low-speed rate exceeded condition exists. This
could indicate a coverage hole. The recommended value is 16%.
Frame Low Speed Rate Low
Watermark
After a low-speed rate exceeded condition exists, the condition persists
until the percentage of low-speed frames drops below this value. The
recommended value is 8%.
Frame Non Unicast Rate
High Watermark
If the non-unicast rate (as a percentage of total frames in an AP) exceeds
this value, a non-unicast rate exceeded condition exists. This value
depends upon the applications used on the network.
Frame Non Unicast Rate Low
Watermark
After a non-unicast rate exceeded condition exists, the condition persists
until the non-unicast rate drops below this value.
Frame Receive Error Rate
High Watermark
If the frame receive error rate (as a percentage of total frames in an AP)
exceeds this value, a frame receive error rate exceeded condition exists.
The recommended value is 16%
Frame Receive Error Rate
Low Watermark
After a frame receive error rate exceeded condition exists, the condition
persists until the frame receive error rate drops below this value. The
recommended value is 8%.
Frame Retry Rate High
Watermark
If the frame retry rate (as a percentage of total frames in an AP) exceeds
this value, a frame retry rate exceeded condition exists. The
recommended value is 16%.
Frame Retry Rate Low
Watermark
After a frame retry rate exceeded condition exists, the condition persists
until the frame retry rate drops below this value. The recommended
value is 8%.
Using the CLI
Use the following command to configure RF event profiles. The available parameters for this profile are
detailed in Table 130.
rf event-thresholds-profile <profile>
bwr-high-wm <percent>
bwr-low-wm <percent>
clone <profile>
detect-frame-rate-anomalies
fer-high-wm <percent>
fer-low-wm <percent>
ffr-high-wm <percent>
ffr-low-wm <percent>
flsr-high-wm <percent>
flsr-low-wm <percent>
fnur-high-wm <percent>
fnur-low-wm <percent>
AOS-W 6.5.3.x | User Guide Access Points | 571