Alcatel-Lucent AOS-W 6.5.3.x - Page 574

574| Access Points AOS-W 6.5.3.x| User Guide
Parameter Description
Driver log level
Enable the level of driver log messages sent to the Syslog server.
n alerts
n critical
n debugging
n emergencies
n errors
n informational
n notifications
n warnings
Console log level
Enable the level of driver log messages sent to the AP console.
n alerts
n critical
n debugging
n emergencies
n errors
n informational
n notifications
n warnings
SAP MTU
MTU, in bytes, on the wired link for the AP. The supported range is 1024-
1578 bytes.
RAP MTU
Configures the maximum size of the GRE packets exchanged between a
RAP and the switch. The supported range is 1024-1578 bytes and the
default value is 120 bytes.
Flex Radio Mode
Enables the flexible radio mode. The flex-radio can be configured in one of
the following modes:
n 5 GHz mode: acts as a single radio operating on 5 GHz band
n 2.4 GHz mode: acts as a single radio operating on 2.4 GHz band
n 2 GHz and 5 GHz mode: acts as two radios (interfaces), one operating
on 5 GHz band, and the other on the 2.4 GHz band. By default, the
flexible radio is set to this mode.
Secondary Master IP/FQDN
The secondary master switch is configured to be used when a Remote AP
is not able to reach the primary master switch.
Spanning Tree Select this checkbox to enable the Spanning Tree protocol.
AP Multicast Aggregation Enable multicast aggregation at the AP.
AP ARP attack Protection Drop ARP packets coming from wired or wireless clients with AP gateway
IP address. In other words, disallow ARP attack from un-trusted ports.
AP multicast aggregation
allowed VLANs
Enable a list of VLANs where APmulticast aggregation is allowed.
Basic AP System Profile Settings—LMS
SAP MTU Maximum Transmission Unit, in bytes, on the wired link for the AP.