576| Access Points AOS-W 6.5.3.x| User Guide
Parameter Description
Remote-AP DHCP Pool
Netmask
Configures a DHCP pool for remote APs. This is the netmask used for the
DHCP pool.
Remote-AP DHCP Lease Time The amount of days that the assigned IP address is valid for the client.
Specify the lease in <days>. A value of 0 indicates the IP address is always
valid; the lease does not expire.
Remote-AP uplink total
bandwidth
This is the total reserved uplink bandwidth (in Kilobits per second).
Remote-AP bw reservation 1
Remote-AP bw reservation 2
Remote-AP bw reservation 3
Session ACLs with uplink bandwidth reservation in kilobits per second. You
can specify up to three session ACLs to reserve uplink bandwidth. The
sum of the three uplink bandwidths should not exceed the Remote-AP
uplink total bandwidth .
Remote-AP Local Network
Access
Enable or disable local network access across VLANs in a Remote-AP.
IPM Configuration
IPM activation
Enable Intelligent Power Monitoring (IPM) system on OAW-AP300 Series,
OAW-AP303H, OAW-AP310 Series, and OAW-AP330 Series access points.
IPM is a feature that actively measures the power utilization of an AP and
dynamically adapts to the power resources.
IPM power reduction steps with
priorities
Set IPM power reduction steps and specify their priorities. The available
power reductions steps are as follows:
n cpu_throttle_25
n cpu_throttle_50
n cpu_throttle_75
n disable_alt_eth
n disable_pse
n disable_usb
n radio_2ghz_chain_1x1
n radio_2ghz_chain_2x2
n radio_2ghz_chain_3x3
n radio_2ghz_power_3dB
n radio_2ghz_power_6dB
n radio_5ghz_chain_1x1
n radio_5ghz_chain_2x2
n radio_5ghz_chain_3x3
n radio_5ghz_power_3dB
n radio_5ghz_power_6dB
Advanced AP System Profile Settings
Bootstrap threshold Number of consecutive missed heartbeats on a GRE tunnel (heartbeats
are sent once per second on each tunnel) before an AP rebootstraps. On
the switch, the GRE tunnel timeout is 1.5 x bootstrap-threshold; the tunnel
is torn down after this number of seconds of inactivity on the tunnel. The
supported range is 1-65535, and the default value is 8.
To Next Page
Loading...