Alcatel-Lucent AOS-W 6.5.3.x - Page 578

578| Access Points AOS-W 6.5.3.x| User Guide
Parameter Description
AeroScout RTLS Server Enables the AP to send AeroScout tag information to an RTLS server. You
must specify the IP address or DNS server and port number of the server
to which location reports are sent.
RTLS station reporting includes information for APs and the clients that
the AP has detected. If you select the Include Unassociated Stations
option, the station reports will also include information about clients not
associated to any AP. By default, unassociated clients are not included in
station reports.
RTLS Server configuration Enables the AP to send RFID tag information to an RTLS server. You must
specify the IP address or DNS server and port number of the server to
which location reports are sent, a shared secret key, and the frequency at
which packets are sent to the server.
RTLS station reporting includes information for APs and the clients that
the AP has detected. If you select the Include Unassociated Stations
option, the station reports will also include information about clients not
associated to any AP. By default, unassociated clients are not included in
station reports. For more information on configuring RTLS server
configuration, see Defining an RTLS Server on page 549.
RTLS Server Compatibility
Mode
The compatibility mode controls the format of tag frames forwarded to
the RTLS server. Enabling this mode will enable legacy format (which
includes a 2 byte padding), and disabling this mode will remove the
padding. The tag frame format will be the same across all AP models.
Slow Timer Recovery by
Rebooting Itself
When enabled, the slow timer recovery feature checks to see if the AP
CPU timer is slow. If it is slow, the AP will restart itself and log the reason
for the reboot. This feature is only supported on OAW-AP103H, and OAW-
RAP108 and OAW-RAP109, which are the only devices that may encounter
the slow timer issue.
Telnet Select this checkbox to enable telnet to the AP.
Disable RAP TFTP Image
Upgrade
Disable TFTP image upgrades for a remote AP.
Spanning Tree Select this checkbox to enable the Spanning Tree protocol.
AP Multicast Aggregation Enable multicast aggregation at the AP.
AP ARP attack Protection Drop ARP packets coming from wired or wireless clients with AP gateway
IP address. In other words, disallow ARP attack from un-trusted ports.
Console Enable Enable the console port on the AP.
AP Console Protection Enable the AP console password.
AP Console Password Set the AP console password on the switch. If the user does not set any
password, the switch generates a default random password which can be
viewed by executing the encrypt disable command followed by the show
ap system-profile <profile-name> command.
Password for Backup
Set a WPA passphrase to generate a pre-shared key for a backup Virtual
AP.
AP USB power Override Enabling override enables the USB port of the AP with POE AT power.