590| Access Points AOS-W 6.5.3.x| User Guide
4. Select the Basic tab on the Profile Details pane, locate the LMS Settings section and specify a unique
IPv4 address in the LMS IP field.
5. In the Profiles pane, select the AP LACP LMS map information profile.
6. In the Profile Details pane, select AP LACP Striping IP to enable the AP LACP striping feature.
7. Enter a GRE striping IP address in the IP field.
8. Enter a LMS IP address in the LMS field.
9. Click Add.
10.Click Apply.
Using the CLI, in AOS-W 6.4.2.x and later
Execute the following on master
Configure lms-ip in ap system-profile even if HA is used since it is used for looking up LACP striping IP.
(host) (config) #ap system-profile LACP
(host) (AP system profile "LACP") #lms-ip 192.0.2.1
(host) (AP system profile "LACP") #bkup-lms-ip 192.0.77.1
(host) (AP system profile "LACP") #write memory
Execute the following commands to configure AP LACP and striping IP on primary LMS or active HA switch:
(host) (config) #ap-lacp-striping-ip
(host) (AP LACP LMS map information) #striping-ip 192.0.2.2 lms 192.0.2.1
(host) (AP LACP LMS map information) #aplacp-enable
Execute the following commands to configure AP LACP LMS on HA standby or backup LMS.
(bkup-host) (config) #ap-lacp-striping-ip
(bkup-host) (AP LACP LMS map information) #striping-ip 192.0.77.2 lms 192.0.2.1
(bkup-host) (AP LACP LMS map information) #aplacp-enable
Using the WebUI in AOS-W 6.3.1.x-6.4.1.x
Follow the procedure to configure the LACP parameters in AP System profile:
1. Navigate to the Configuration > Advanced Services > All Profiles page.
2. Expand the AP profiles menu in the Profiles pane
3. Expand the AP System profiles menu, and select the AP system profile you want to modify.
4. In the Profile Details pane, select the Basic tab, locate the LMS Settings section and a specify a unique
IPv4 address in the LMS IP field.
5. Click Apply.
Using the CLI in AOS-W 6.3.1.x-6.4.1.x
Execute the following commands to configure the LACP parameters (LMS IP and the GRE striping IP) on an AP
system profile.
(host) (config) #ap system-profile LACP
(host) (AP system profile "LACP") #lms-ip 192.0.2.1
(host) (AP system profile "LACP") #gre-striping-ip 192.0.2.2
Execute the following commands to configure AP LACP LMS on HA standby or backup LMS.
If the lms-ip is not specified in the AP system profile, you can create an entry in ap-lacp-striping-ip profile with just
the striping-ip. The lms-ip value in the ap-system-profile is used as a key to look up entries in ap-lacp profile on all
the switches that an AP can terminate on. This also helps in selectively disabling Ling Aggression on some APs by not
configuring lms-ip in their ap-system-profile.
To Next Page
Loading...