Alcatel-Lucent AOS-W 6.5.3.x - Page 61

61| Control Plane Security AOS-W 6.5.3.x| User Guide
ap-name <ap_name>
description <description>
To add an AP to the remote AP whitelist:
(host)#whitelist-db rap add mac-address <mac-address>
ap-group <ap-group>
ap-name <ap-name>
description <description>
full-name <name>
remote-ip <inner-ip-adr>
Viewing APWhitelist Status
The WebUI displays either a status of the selected APwhitelist or a table of entries in the selected APwhitelist.
The status page displays the current status of the APwhitelist and for switches in a master/local switch
topology, it displays the APwhitelist synchronization status between switches. When the status of an entry in
the APwhitelist changes, the APwhitelist status is updated automatically. The table of entries page displays the
status of each APon the APwhitelist.
The Configuration > Wireless > AP Installation > Whitelist tab displays the status of the campus AP
whitelist by default. To view the status of remote AP whitelist, click the Remote AP link.
The following table describes the contents of the status page.
Status Entry Description
Campus AP whitelist status information
Control Plane Security Shows if the control plane security is enabled or disabled on the switch.
This status entry is also a link to the control plane security configuration
tab.
Total entries Number of entries in the campus APwhitelist.
Approved entries Number of entries in the campus AP whitelist that have been approved by
the switch.
Unapproved entries Number of entries in the campus APwhitelist that have not been approved
by the switch.
Certified entries Number of entries in the campus AP whitelist that have an approved
certificate from the switch.
Certified hold entries Number of entries in the campus AP whitelist that have been certified with
a factory certificate but request to be certified again. Such APs are not
approved as secure until you manually change the status and verify that it
is not compromised.
NOTE: If an AP is in the hold state because of connectivity problems, then
the AP recovers and moves out of the hold state when connectivity is
restored.
Revoked entries Number of entries in the campus AP whitelist that has been manually
revoked.
Marked for deletion entries Number of entries in the campus AP whitelist that has been marked for
deletion, but not removed from the Remote APwhitelist.
Remote AP whitelist configuration parameters
Table 19: Whitelist Status Information