Alcatel-Lucent AOS-W 6.5.3.x - Page 63

63| Control Plane Security AOS-W 6.5.3.x| User Guide
ap-group <ap_group>
ap-name <ap_name>
cert-type {factory-cert|switch-cert}
mac-address <name>
page <num>
start <offset>
state {approved-ready-for-cert|
certified-factory-cert|
unapproved-factory-cert|
unapproved-no-cert}
(host) #show whitelist-db cpsec-status
(host) #show whitelist-db rap
apgroup <rap-group>
apname <rap-name>
fullname <rap-fullname>
long
mac-address <mac-address>
page <page-number>
start <offset>
(host) #show whitelist-db rap-status
Modifying an AP in the Campus AP Whitelist
Use the following procedures to modify the APgroup, AP name, certificate type, state, description, and revoked
status of an AP in the campus APwhitelist.
In the WebUI
To modify an AP in the campus AP whitelist:
1. Navigate to Configuration > Wireless > AP Installation.
2. Click the Whitelist tab.
3. Click the Entries>> button.
4. Select the checkbox of the AP that you want to modify, then click Modify.
If your campus AP whitelist is large and you cannot immediately locate the AP that you want to modify,
select the Search link. The Whitelist Search tab displays the fields APGroup, Cert Type, APMAC
Address, AP Name, and State that allow you to search for an AP. Specify the values of the AP that you
want to locate in these fields, then click Search. The campus APwhitelist displays a list of APs that match
your search criteria. Select the checkbox of the APthat you want to modify, then click Modify.
5. Modify the settings of the selected AP. Some of the following parameters are available when adding an
APto the campus AP whitelist and are described in Table 18.
n AP Group: The name of the AP group to which the campus AP is assigned.
n AP Name: The name of the campus AP. If you not specify a name, the AP uses its MAC address as a
name.
n Cert-type: The type of certificate used by the AP.
l switch-cert: The campus AP is using a certificate signed by the switch.
l factory-cert: The campus AP is using a factory-installed certificate.
n State: When you click the State drop-down list to modify this parameter, you may choose one of the
following options:
l approved-ready-for-cert: The AP has been approved state and is ready to receive a certificate.
l certified-factory-cert: The AP is certified and has a factory-installed certificate.
n Description: Brief description of the campus AP.
n Revoked: Click the Revoked checkbox to revoke an invalid or rogue AP.