Alcatel-Lucent AOS-W 6.5.3.x - Page 69

69| Control Plane Security AOS-W 6.5.3.x| User Guide
In the CLI
To view the master or local switch whitelists via the command-line interface, issue the following commands:
(host)#show whitelist-db cpsec-master-switch-list [mac-address <mac-address>]
(host) #show whitelist-db cpsec-local-switch-list [mac-address <mac-address>]
Deleting an Entry from the Master or Local Switch Whitelist
You do not need to delete a master switch from the master switch whitelist during the course of normal
operation. However, if you remove a local switch from the network, you should also remove the local switch
from the local switch whitelist on the master switch. If the local switch whitelist contains entries for switches no
longer on the network, then a campus AP whitelist entry can be marked for deletion but is not physically
deleted, as the switchis waiting for an acknowledgment from another switch no longer on the network. This
can increase network traffic and reduce memory resources on the switch.
In the WebUI
To delete an entry from the master or local switch whitelist:
1. Navigate to Configuration > Switch.
2. Select the Control Plane Security tab.
3. To delete an entry from the Local Switch Whitelist: In the Local Switch List For AP Whitelist Sync
section, click the Delete button by each switch entry you want to remove.
Or,
To delete an entry from the Master Switch Whitelist: In the Master Switch List For AP Whitelist Sync
section, click Delete by each switch entry you want to remove.
4. Click Apply.
In the CLI
To delete an entry from the master or local switch whitelist:
(host) #whitelist-db cpsec-master-switch-list del mac-address <mac-address>
(host) #whitelist-db cpsec-local-switch-list del mac-address <mac-address>
Purging the Master or Local Switch Whitelist
There is no need to purge a master switch whitelist during the course of normal operation. If, however, you are
removing a switch from the network, you can purge its switch whitelist after it has been disconnected from the
network. To clear a local switch whitelist entry on a master switch that is still connected to the network, select
that individual whitelist entry and delete it using the delete option.
In the WebUI
To purge a switch whitelist:
1. Navigate to Configuration > Switch.
2. Select the Control Plane Security tab.
3. To clear the Local Switch whitelist: In the Local Switch List For AP Whitelist Sync section, click Purge.
Or,
4. To clear the Master Switch whitelist: In the Master Switch List For AP Whitelist Sync section, click
Purge.