EasyManua.ls Logo

Alcatel-Lucent AOS-W 6.5.3.x - Page 744

Alcatel-Lucent AOS-W 6.5.3.x
1160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
744| Remote Access Points AOS-W 6.5.3.x| User Guide
S - Src NAT with VLAN IP, E - L2 Enforced, F - IPIP Force Delete, O - VOIP user, I - Interim
stats,
C - Inactive, D - Suppress Idle TMO, m - IP mobile user anchor, H - 1st DHCP sent to AUTH
FM(Forward Mode): S - Split, B - Bridge, N - N/A
IP MAC ACLs Contract Location Age Sessions Flags Vlan
--------------- ----------------- ------- --------- -------- --- --------- ----- ----
10.15.72.50 00:0B:86:61:12:AC 2703/0 0/0 0 16 1/65535 P 0
10.15.72.253 00:18:8B:A9:A8:DF 52/0 1/2 0 1 0/65535 1
192.168.11.1 00:0B:86:66:03:3F 2700/0 0/0 0 20024 0/65535 P 177
10.15.196.249 00:0B:86:66:03:3F 2700/0 0/0 0 3 1/65535 P 1
FM IdleTMO
-- --------
N 300
S 300
N 300
N 300
The following is a sample output for a per-user configuration:
(host) #show datapath user ap-name rap5-2
Datapath User Table Entries
---------------------------
Flags: P - Permanent, W - WEP, T- TKIP, A - AESCCM, G - AESGCM, V - ProxyArp to/for MN
(Visitor),
N - VPN, L - local, Y - Any IP user, R - Routed user, M - Media Capable,
S - Src NAT with VLAN IP, E - L2 Enforced, F - IPIP Force Delete, O - VOIP user, I - Interim
stats,
C - Inactive, D - Suppress Idle TMO, m - IP mobile user anchor, H - 1st DHCP sent to AUTH
FM(Forward Mode): S - Split, B - Bridge, N - N/A
IP MAC ACLs Contract Location Age Sessions Flags Vlan
FM
--------------- ----------------- ------- --------- -------- --- --------- ----- ----
10.15.72.50 00:0B:86:61:12:AC 2703/0 0/0 0 11 0/65535 P 0
10.15.72.253 00:18:8B:A9:A8:DF 52/0 3/4 0 46 0/65535 1
192.168.11.1 00:0B:86:66:03:3F 2700/0 0/0 0 20883 0/65535 P 177
10.15.196.249 00:0B:86:66:03:3F 2700/0 0/0 0 15 1/65535 P 1
FM IdleTMO
-- --------
N 300
S 300
N 300
N 300
Verifying Bandwidth Contracts During Data Transfer
You can verify the Bandwidth Contracts that are in use during data transfer using CLI.
The following is a sample output for a per-role configuration:
(host) #show datapath session ap-name rap5-2 table 10.15.72.99
Datapath Session Table Entries
------------------------------
Flags: F - fast age, S - src NAT, N - dest NAT
D - deny, R - redirect, Y - no syn
H - high prio, P - set prio, T - set ToS
C - client, M - mirror, V - VOIP
Q - Real-Time Quality analysis
I - Deep inspect, U - Locally destined
E - Media Deep Inspect, G - media signal
r - Route Nexthop
A - Application Firewall Inspect

Table of Contents