746| Remote Access Points AOS-W 6.5.3.x| User Guide
5. Select the Disable RAP Tftp Image Upgrade check box.
Note: Selecting the check box disables the TFTP image upgrade. Clearing the check box enables the TFTP
image upgrade.
6. Click Apply.
In the CLI
The following commands enables or disables the TFTP image upgrade on a RAP:
(host) (config) #ap system-profile default
(host) (AP system profile "default") #[no] disable-tftp-image-upgrade
(host) (AP system profile "default") #write memory
The following command displays if the TFTP image upgrade is enabled or disabled in the AP system profile:
(host) #show ap system-profile default
AP system profile "default"
---------------------------
Parameter Value
--------- -----
RF Band g
RF Band for AM mode scanning all
Native VLAN ID 10
Tunnel Heartbeat Interval 1
Session ACL ap-uplink-acl
Corporate DNS Domain N/A
SNMP sysContact N/A
LED operating mode (11n/11ac APs only) normal
LED override Disabled
Driver log level warnings
Console log level emergencies
SAP MTU N/A
RAP MTU 1200 bytes
LMS IP N/A
Backup LMS IP N/A
LMS IPv6 N/A
Backup LMS IPv6 N/A
LMS Preemption Disabled
LMS Hold-down Period 600 sec
LMS ping interval 20
Remote-AP DHCP Server VLAN N/A
Remote-AP DHCP Server Id 192.168.11.1
Remote-AP DHCP Default Router 192.168.11.1
Remote-AP DHCP DNS Server N/A
Remote-AP DHCP Pool Start 192.168.11.2
Remote-AP DHCP Pool End 192.168.11.254
Remote-AP DHCP Pool Netmask 255.255.255.0
Remote-AP DHCP Lease Time 0 days
Remote-AP uplink total bandwidth 0 kbps
Remote-AP bw reservation 1 N/A
Remote-AP bw reservation 2 N/A
Remote-AP bw reservation 3 N/A
Remote-AP Local Network Access Disabled
Bootstrap threshold 8
Double Encrypt Disabled
Dump Server N/A
Heartbeat DSCP 0
Maintenance Mode Disabled
Maximum Request Retries 10
Request Retry Interval 10 sec
Number of IPSEC retries 85
To Next Page
Loading...