Alcatel-Lucent AOS-W 6.5.3.x - Page 917

917| 802.11u Hotspots AOS-W 6.5.3.x| User Guide
Parameter Description
Icon2 type Icon file type. This value can be IANA MIME media types image/png,
image/jpg or image/jpeg.
Icon2 filename File name of an icon for the second OSU in the list.
Number of Service Description
Configured
Number of service descriptions in the OSU provisioning list.
OSU Service Description 1
Language Code
An ISO 639 language code that identifies the language used in the srvc-
desc1 field.
OSU Service Description 1 Text string describing an Online Sign-Up (OSU)service. If the description
includes spaces, enclose the description in quotation marks (").
Configure this parameter only if the associated language code is eng
(English).
OSU Service Description 1 in
HEX
Description of an Online Sign-Up (OSU)service in hexadecimal
characters. Configure this string for a service description that requires
special characters, or if the language code is set to any language other
than eng.
OSU Service Description 2
Language Code
An ISO 639 language code that identifies the language used in the srvc-
desc2 field.
OSU Service Description 2 Text string describing a second Online Sign-Up (OSU)service. If the
description includes spaces, enclose the description in quotation marks
(").
Configure this parameter only if the associated language code is eng
(English).
OSU Service Description 2 in
HEX
Description of a second Online Sign-Up (OSU)service, in hexadecimal
characters. Configure this string for a service description that requires
special characters, or if the language code is set to any language other
than eng.
HS 2.0 OSU Provider Method
Select one of the OSUprovider provisioning methods:
n OMA-DM: Open Mobile Alliance (OMA) Device Management (DM)
n SOAP-XML: Simple Object Access Protocol/Extensible Markup
Language
In the CLI
To configure an OSU provider list profile in the command-line interface, access the CLI in config mode and issue
the following command:
(host) (config) # wlan hotspot h2qp-osu-prov-list-profile <profile>
Uploading an Icon file
To upload a OSU provider icon into the switch flash drive using the WebUI:
1. Navigate to Maintenance > File > Copy Files
2. In the Source Selection field, select the method you will use to upload the source file. If you are uploading
the icon file from an external source, you are prompted to enter details such as the external Host IP
address.
3. In the Destination Selection section, select Flash File System, and enter a name for the icon file.
4. Click Apply.