Alcatel-Lucent AOS-W 6.5.3.x - Page 926

Parameter Description
Probe Mode
Click the Probe Mode drop-down list and select ping to enable this feature.
Probe Interval (sec)
The Probe Interval field specifies the probe interval, in seconds. The WAN health-check
feature sends the number of probes defined by the Pocket Burst per Probe parameter
during each probe interval. To change the default interval of 10 seconds, enter a new
value into this field.
PacketBurst Per Probe
The Pocket Burst per Probe field specifies the number of probes to be sent during the
probe interval. To change the default value of 5 probes, enter a new value into this field.
Probe Retries
The number of times the switchattempts to resend a probe.
Table 220: WAN Health Check Settings
In the CLI
(host) (config) #uplink enable
(host) (config) #uplink wired priority 200
(host) (config) #uplink cellular priority 100
(host) (config) #uplink health-check enable
(host) (config) #uplink health-check ip '192.0.2.2'
AOS-W 6.5.3.x | User Guide Adding Local Switches | 926