Alcatel-Lucent AOS-W 6.5.3.x - Page 938

938| Voice and Video AOS-W 6.5.3.x| User Guide
Parameter Description
VoIP Drop SIP Invite and send
status code (client)
Click the VoIP Drop SIP Invite and send status code (client) drop-
down list and select one of the following status codes to be sent back to
the client:
n 480: Temporary Unavailable
n 486: Busy Here
n 503: Service Unavailable
n none: Don't send SIP status code
VoIP Drop SIP Invite and send
status code (server)
Click the VoIP Drop SIP Invite and send status code (client)drop-down
list and select one of the following status codes to be sent back to the
server:
n 480: Temporary Unavailable
n 486: Busy Here
n 503: Service Unavailable
n none: Don't send SIP status code
Allow Idle VOIP Client If enabled, the AP allows idle voice clients to associate even if the AP
reaches its call capacity limit.
If disabled, the AP rejects idle voice clients to associate if the AP reaches
its call capacity limit. However, the AP continues to allow active (in-call)
and non-voice clients to associate.
This setting is disabled by default.
5. Click Apply.
In the CLI
To configure a VoIP Call Admission Control profile:
(host)(config)#wlan voip-cac-profile <profile>
allow-idle-voip-client
bandwidth-cac
bandwidth-capacity <bandwidth-capacity>
call-admission-control
call-capacity
call-handoff-reservation <percent>
disconnect-extra-call
send-sip-100-trying
send-sip-status-code client|server <code>
wmm-tspec-enforcement
wmm-tspec-enforcement-period <seconds>
Understanding Wi-Fi Multimedia
Wi-Fi Multimedia (WMM), is a Wi-Fi Alliance specification based on the IEEE 802.11e wireless Quality of Service
(QoS) standard. WMM works with 802.11a, b, g, n, and ac physical layer standards.
WMM supports four access categories (ACs): voice, video, best effort, and background. Table 225 shows the
mapping of the WMM access categories to 802.1p priority values. The 802.1p priority value is contained in a
two-byte QoS control field in the WMM data frame.