Alcatel-Lucent AOS-W 6.5.3.x - Page 968

968| Voice and Video AOS-W 6.5.3.x| User Guide
Parameter Description
Action Action to be taken when the filter matches the traffic pattern. The values can be:
n drop
n dst-nat
n dual-nat
n permit
n redirect to esi
n redirect to tunnel
n reject
n route
n route dst-nat
n src-nat
Queue Queue priority of the flow. The values can be:
n Low
n High
Classify Media Enable this setting to identify the voice or video flow based on a deep packet inspection
and analysis of the actual traffic.
NOTE: Enable this setting only for voice or video signaling/control session as it causes
deep packet inspection of all UDP flows to and from the user.
Table 236: Session Rule Parameters
6. Click Apply.
Apple FaceTime Session Identification
The switch can determine if the media session is a FaceTime session by searching the presence of a pattern in
the User-Agent field of the SIP signaling message header. Apple refers the internal name of FaceTime session as
"Viceroy". "Viceroy" is the User-Agent string of the SIP signaling message header. A provision to configure this
string is available in the switch in case a new version of Apple FaceTime uses a different User-Agent string other
than "Viceroy".
Do not configure this feature unless a new version of the Apple FaceTime uses a different User-Agent string other
than "Viceroy". Contact Alcatel-Lucent Technical Support for more information.
In the WebUI
The following procedure configures a pattern to recognize FaceTime sessions using the WebUI.
1. Navigate to Configuration >Advanced Services > All Profiles.
2. Expand Other Profiles and click Apple Facetime Config.
3. In the Profile Details section, enter a string in the Pattern to recognize Facetime field.
4. Click Save.
In the CLI
The following commands configures a pattern to recognize Apple FaceTime sessions using the CLI.
(host) (config) #voice facetime
(host) (Apple Facetime Config) #pattern <pattern>
The following command displays the pattern configured using the CLI.
(host) #show voice facetime
Apple Facetime Config
---------------------
Parameter Value