Publication 1756-UM514B-EN-P - February 2003
3-14 Using Programming Software in DH+ Applications
RSLogix 500 DH+ Application Example
Figure 3.5 shows an example DH+ application that includes SLC-5s
using the 1756-DHRIO module to write message instructions.
Figure 3.7
For this example, you must configure a routing table in RSLinx as
described in the steps beginning on
page 3-5 and then use
RSLogix 500 to complete the message instructions as described on
page 3-12. Figure 3.8 shows the screens needed to complete the
example.
Figure 3.8
ControlLogix chassis
1756-DHRIO
SLC-504 processor A
node number: 015
DH+ link
Link ID 1
SLC-504 processor B
node number: 025
19765
1756-DHRIO
DH+ link
Link ID 2
Channel B
node number: 020
Channel B
node number: 030
Routing table RSLogix 500 message instruction
To Next Page
Loading...
