Geometries with orientation support
200 Rockwell Automation Publication MOTION-UM002F-EN-P - February 2018
Example Start Region End Region Notes
4 Mirror flip Mirror flip Starting orientation [Rx=0, Ry=(-78), Rz=180] with MCPM move to orientation [Rx=0, Ry=78, Rz=180].
The resultant move takes the longest rotary path move to avoid travel through 0
in the Mirror flip region, or +204
on Ry (-204
for J5).
Shortest rotary path move for Ry is not allowed in the Mirror flip region.
5 -- ---
This is a very specific case involving a move from home position [Rx=180, Ry=0] to absolute position [Rx=0, Ry=0]. This
move is not allowed due to ambiguity of the direction of travel (either positive or negative direction would be correct, yet
indeterminate from the absolute orientation specified).
Tip: An incremental Ry move of distance 180 is allowed here - the direction of the move is explicitly specified by the
sign of the distance parameter.
6 Mirror flip Mirror flip
Shortest rotary path move for Ry is not allowed in the Mirror flip region. Example 4 shows how such a move is planned.
Tip: Incremental moves are not limited like absolute moves are. However, such incremental Ry moves will encounter
transformation error when attempting to cross zero degrees (J5 = +/- 180
) in the Mirror flip region.
See also
Mirror orientation restrictions on page 198
Use the MCTO instruction to establish a bidirectional transform between
Cartesian and robot system with coordinates that are joint axes of a robot.
The Cartesian system coordinates are defined by XYZ translation coordinates and
RxRyRz orientation coordinates in the fixed angle convention.
turns counters
To Next Page
Loading...
