Rockwell Automation Publication IASIMP-QS035B-EN-P - April 2015 29
Prepare the Kinetix 5500 Drive Hardware Chapter 1
2. Position the exposed portion of the cable braid directly in line with the clamp.
3. Tighten the clamp screws to a torque v
alue of 2.0 N•m (17.7 lb•in) maximum.
4. Repeat
step 1 through step 3 for each drive in multi-axis configurations.
When the drive/motor combination calls for 14 AWG or 10 AWG cable, the feedback cable routes along with the power and brake wiring.
Motor Cable
Shield Clamp
Motor Power
(MP) Connector
Motor Brake
(BC) Connector
Exposed shield braid
under clamp.
Cable clamp screws
tightened.
Feedback cable routed
within the shield braid.
Kinetix 5500 Servo Drives
(frame 2 or 3) Front View
2198-KITCON-DSL
Motor Feedback
Connector Kit
Retention Screw
(loosen, do not remove)
Clamp features apply to all
frame sizes.
Torque clamp screws to
2.0 N•m (17.5 lb-in), max
2090-CSBM1DF-14AAxx or
2090-CSBM1DF-10AAxx Motor Cables
Figure 6 - 14 AWG and 10 AWG Cable Installation
To Next Page
Loading...
